The following table lists the changes that will occur when you select domestic default using MENU 703:
| Program Option | Domestic Default Value |
| All Trouble Reports (MENU 317) | Disabled |
| All Bypass Reports (MENU 317) | Disabled |
| All Restore Reports (MENU 317) | Disabled |
| Destination 1 TX Format (MENU 540) | Domestic PSTN |
| Access Route (MENU 160) | Log Only |
| Open/Close Route (MENU 222) | Log Only |
| Test Route (MENU 542) | Log Only |
| System Route (MENU 543) | Log Only |
If your system has already been set to be "Domestic PSTN" and you want to change the report functions back to "Contact ID" reporting (aka Back-to-Base monitoring), there is no need to do a factory default. You can modify the above options like below:
| Program Option | Contact ID Value |
| All Trouble Reports (MENU 317) | Enabled |
| All Bypass Reports (MENU 317) | Enabled |
| All Restore Reports (MENU 317) | Enabled |
| Destination 1 TX Format (MENU 540) | Contact ID PSTN |
| Access Route (MENU 160) | Dest 1 + Log |
| Open/Close Route (MENU 222) | Dest 1 + Log |
| Test Route (MENU 542) | Dest 1 + Log |
| System Route (MENU 543) | Dest 1 + Log |